Inhaltsverzeichnis   MOBOTIX Online-Hilfe Sprache: en  

Routing

Open the Routing dialog to define the routes to be used by the camera for connecting to different networks. Connections via the Ethernet interface can be used as well as ISDN data connections.

In general, the camera can only send network data using a connection previously configured in the Ethernet Interface and ISDN Data Connections (Dial-In Connection or Dial-Out Connections tabs) dialogs.

Note: Make sure that you create a route for every ISDN dial-out connection; otherwise the camera does not dial out.

Introduction

A network is defined by the network address and the network mask. For example, by factory default the camera is configured to an IP address within the network 10.0.0.0/255.0.0.0 (network address/network mask).

Networks are connected through gateways. This may be an ISDN router or a special computer within the network.

In order for each computer within the network to know if and how it can connect to computers in other networks, you need to configure routes. A route consists of the following information:

When a network package is to be sent to a specific target IP address, the camera checks if a route exists for this address. If no specific route exists, or no routes have been defined, the so-called Default Route is used.

The Default Route

Select the connection to be used by default. In general, this is the connection to your Internet Service Provider or to the closest gateway.

When you select the Ethernet Interface connection, you need to enter the IP address of the Gateway. Valid gateway IP addresses need to be accessible within the camera's local network (as defined in the Ethernet Interface dialog).
Note: When you have activated the BOOTP/DHCP option in the Ethernet Interface dialog, the Default Route is always set to the Ethernet Interface with the Gateway IP Address being determined automatically.

When you select an ISDN Dial-Out Connection, the camera accepts the DNS server's IP address proposed by the service provider.

Network Routes

Enter the routes to other networks.

For additional information on the topic, see the Routing - Example help topic.


Storing the Configuration

Click on the Set button to save your settings until the camera is rebooted.

Click on the Close button to close the dialog. While closing the dialog, the system checks the entire configuration for changes. If changes are detected, you will be asked if you would like to store the entire configuration permanently.

In order to enable these settings, you need to reboot the camera!

Andere Sprachen: de, en

©2001-2024 MOBOTIX AG, Germany · http://www.mobotix.com/